~/tools/

Square Up Layout Calculator

Units
Precision

Shape and diagonal

Enter the two sides. When the measured diagonals match this length, the corners are square.

Shape
Color

Diagonal and size

Diagonalboth diagonals, corner to corner
15' 7 7/16"
Perimeter
44' 0"
Area
120.00 sq ft

Diagonal check

Square up: diagonal

Printing uses the real sizes. Set the printer scale to 100% and check one dimension with a tape before cutting.

15' 7 7/16"12' 0"10' 0"90°

Adjust the diagonal from two reference stakes

Working alone with string lines and batterboards: fix one side between two stakes (A and B), run the next side from A past its corner to a batterboard, measure the diagonal from B, and this tells you how far to slide the string on the batterboard.

The side already fixed
A to the corner being squared
Corner to the batterboard along the string
As measured now

Adjustment

Correct diagonal
20' 0"
Out of squarediagonal is short, corner closed in
−1 1/2"
Move string on batterboardaway from the reference side
2 13/16"
Corner movesat the far end of the side
2 1/2"
Corner angle now
89.26°

Current and correct string lines

Square up: adjust the diagonal

Printing uses the real sizes. Set the printer scale to 100% and check one dimension with a tape before cutting.

ABreference 12' 0"90°side 16' 0"now 19' 10 1/2"correct 20' 0"move 2 13/16" ◂

Current string and diagonalCorrect string and diagonalThe swing is exaggerated to 6° so the two lines can be told apart; the move distance is exact.

Squaring up a layout on your own

  1. Set two stakes for one side at its exact length. This is the reference side, A to B. Everything else is squared from it.
  2. From A, run a string for the next side past its corner to a batterboard, and mark the corner on the string at the side length.
  3. Measure from B to that corner mark. Enter it above as the current diagonal; the tool gives the correct diagonal and how far to slide the string on the batterboard.
  4. Move the string that much on the batterboard, re-measure the diagonal and repeat until it matches. Each move is proportional, so it usually takes one or two tries.
  5. Once this side is square, use it and the reference side to set the remaining corners, checking both diagonals of the finished rectangle against the diagonal above.

Lumber: nominal to actual

Enter actual finished sizes in every tool. A nominal 2x4 is cut and dressed to the size shown.

NominalActual
1x23/4" x 1 1/2"
1x33/4" x 2 1/2"
1x43/4" x 3 1/2"
1x63/4" x 5 1/2"
1x83/4" x 7 1/4"
1x103/4" x 9 1/4"
1x123/4" x 11 1/4"
2x21 1/2" x 1 1/2"
2x31 1/2" x 2 1/2"
2x41 1/2" x 3 1/2"
2x61 1/2" x 5 1/2"
2x81 1/2" x 7 1/4"
2x101 1/2" x 9 1/4"
2x121 1/2" x 11 1/4"
4x43 1/2" x 3 1/2"
4x63 1/2" x 5 1/2"
6x65 1/2" x 5 1/2"
The link carries every input, so it opens the same calculation on a phone.