Kerf bending
Kerfs are cut across the inside face, leaving a skin on the outside. Each kerf closes by the blade width as the board turns, so the spacing follows the radius.
Bend as
Kerf count
Kerfs
- Kerfs11.25° each; a kerf closes fully at 11.46°
- 8
- Kerf spacingcentre to centre on the outside face
- 1 5/16"
- Kerf depthleaves 1/8"
- 5/8"
- Bend lengthalong the outside face; first kerf half a spacing in
- 10 5/8"
- Inside arcon the 6" radius
- 9 7/16"
- Outside arcon the 6 3/4" radius
- 10 5/8"
- Gap left in each kerfon the inside face after bending; glue fills it
- 0"
Board flat
Kerfed board
Printing uses the real sizes. Set the printer scale to 100% and check one dimension with a tape before cutting.
Board bent
Bent board
Printing uses the real sizes. Set the printer scale to 100% and check one dimension with a tape before cutting.
| # | Position |
|---|---|
| 1 | 11/16" |
| 2 | 2" |
| 3 | 3 5/16" |
| 4 | 4 5/8" |
| 5 | 5 15/16" |
| 6 | 7 5/16" |
| 7 | 8 5/8" |
| 8 | 9 15/16" |
Kerf layout strip
Kerf centre lines at true size along the outside face. Print at 100%, tape the segments end to end in order and transfer the marks to the board.
Kerf layout strip
Printing uses the real sizes. Set the printer scale to 100% and check one dimension with a tape before cutting.
The link carries every input, so it opens the same calculation on a phone.